Crittenden Metal Roof Coating
Metal roof coating in Crittenden for farm and equipment buildings on open ground, starting with a storm and hail check of skylight panels, ridge caps, and gutters.
Storm Checks Come Before The Coating
Farm and equipment buildings around rural Crittenden sit on open ground with exposed-fastener roofs, translucent skylight panels, and long unheated bays. After a hailstorm, the questions are what got damaged, what still sheds water, and what needs repair before any coating goes on.
A coating seals small dents and loose screws but adds little impact strength, so storm damage gets repaired first.
- Skylight panels checked for cracks
- Ridge caps and rake trim checked for lift
- Gutters checked for dents that hold water
- Dated photos taken for your insurer
What We Check After A Crittenden Storm
After a storm we check these five spots on a farm or equipment building. Numbers match the plan.
Ridge Caps In Open Wind
Wind across open fields lifts cap edges and works screws loose. Lifted caps get reset and screwed tight every few inches.
Dented Panels Between Purlins
Hail dents panels without breaking the steel, and dented panels still shed water. We mark them and check the screws around each dent.
End Laps On The Lower Slope
Rust starts at end laps and the lower eave on these buildings, and a storm can open a lap that was already weak.
Translucent Skylight Panels
Yellowed skylight panels crack under hail before steel does. Cracked and brittle panels get replaced or covered over.
Gutters Along The Eave
Dented gutters hold water and rust at the low spots. Bad sections get swapped and hangers reset so water runs to the downspouts.
Benefits of Coating Your Roof
Gains on a farm building that just came through a storm.
Small Dents Sealed
Coating seals small hail dents and the loosened screws around them once the damaged parts of the roof are fixed.
Washers Out Of The Weather
Fastener washers dried out by years of sun go under a membrane, which slows the next round of leaks at the screws.
Cooler Unheated Bays
A reflective topcoat cuts the heat under a bare steel roof, so stored equipment and feed sit cooler in summer.
Repairs Documented
Dated photos of the damage and the repairs give you a record of the roof for your insurer and later inspections.
Commercial Roof Coating Options for Crittenden
Systems we use on farm and equipment buildings around Crittenden.
Metal Roof Coating
Our metal roof coating seals screws, laps, and small dents on exposed-fastener barns after storm repairs.
Metal roof coating →
Acrylic Roof Coating
Sloped barns that drain fast take acrylic over primed steel, a good match for unheated buildings.
Acrylic roof coating →
Spray Foam Roofing
Shops with a heated office under the metal can take foam, which adds insulation and some cushion against hail.
Spray foam roofing →
Hail Just Came Through?
Call us and we will set a time to check the skylight panels, ridge caps, and gutters. Take your own dated photos before anything gets moved.
How A Storm Check Turns Into A Coated Roof
Damage gets documented and repaired before any coating starts.
Inspect Your Roof
We walk the roof after the storm, mark dents, cracked skylight panels, lifted trim, and dented gutters, and take dated photos you can give your insurer.
Talk With Your Insurer
Coverage terms vary by policy, so questions about roof damage go to your carrier and adjuster before repairs start; our photos and notes go with you.
Repair Storm Damage
Cracked skylight panels, torn flashing, split seams, and bad gutter sections get replaced, and lifted caps get re-fastened.
Clean, Prime, And Seal
Panels get washed and primed, and the screws around each dent get tightened or upsized and capped with sealant.
Coat The Roof
Base and topcoats go on to the specified thickness, sealing small dents and screw heads under one membrane.
Nearby Towns We Work In
Crittenden is in our coverage, along with the towns below. Building outside them? call us or send us a message.
Walton
Long warehouse roofs near the interstate split.
- End laps that open and collect debris
- Gutters on wide roof faces
- Transitions between roof sections
Taylor Mill
Hillside buildings with one eave near the ground.
- Debris piled at uphill eaves
- Downspouts onto lower roofs
- Level ground for lifts
Alexandria
Shingle roofs in town, pole barns on US 27.
- Shingle roofs needing maker approval
- Pole barn screws and end laps
- Retail skylight panels
Dry Ridge
Busy interchange lots with shingle and metal roofs.
- Rooms kept open by section
- Overspray control near cars
- Wind at trim on high ground
Crittenden Metal Roof Coating Questions
Do roof coatings help with hail and storm damage?
Coatings seal small hail dents and loose fasteners but add little impact strength, so storm damage gets inspected and repaired first. Dented panels still shed water if the steel is unbroken, while split seams, torn flashing, and cracked skylight panels need repair. Check skylight panels, ridge caps, rake trim, and gutters, and keep dated photos for your carrier.
Who handles building inspections in Crittenden?
Check with the City of Crittenden first, then the Grant County building inspector listed on Kentucky's contact sheet for the county. Crittenden sits along I-75 near the Boone and Kenton lines, so confirm the county on the deed before calling. Replacing rusted-through panels, adding foam that raises the roof edge, or cutting new openings all raise permit questions.
What should farm and equipment building owners near Crittenden know?
These buildings are classic coating candidates: exposed-fastener metal, translucent skylight panels, and long unheated bays on open ground. Work focuses on rust at end laps and the lower eave, washers dried out by sun, yellowed and cracked skylight panels, and ridge caps lifted by wind. Rural accounts here get power from Owen Electric Cooperative or Duke Energy Kentucky.
Should I coat right after a hailstorm?
Repair first, coat after. Coating over cracked skylight panels or split seams traps the problem under the membrane. Once the damage is documented and fixed, the roof is ready to clean, prime, and coat on a dry day.
Can coating work be planned around feeding and loading times?
Yes. On farm buildings with livestock or stored feed, work breaks get planned around feeding and loading, and lifts get staged away from gates and loading doors.
Get Your Farm Building Checked And Coated
Get a ballpark figure online, or call us after the storm and we will start with the skylight panels and ridge caps.